Technical Papers

Elastic Properties of Fractured Rock Masses With Frictional Properties and Power Law Fracture Size Distributions

Davy, P.1, Darcel, C.2, Le Goc, R.2, & Mas Ivars, D.3,4

1.Université Rennes, CNRS, Géosciences Rennes, UMR 6118, Rennes, France,
2.
Itasca Consultants SAS, Écully, France,
3.Swedish Nuclear Fuel and Waste Management Company, SKB, Solna, Sweden,
4.KTH Royal Institute of Technology,Stockholm, Sweden

Davy, P., Darcel, C., Le Goc, R., & Mas Ivars, D. (2018). Elastic Properties of Fractured Rock Masses With Frictional Properties and Power Law Fracture Size Distributions. Journal of Geophysical Research: Solid Earth. doi:10.1029/2017jb015329

Abstract

We derive the relationships that link the general elastic properties of rock masses to the geometrical properties of fracture networks, with a special emphasis to the case of frictional crack surfaces. We extend the well-known elastic solutions for free-slipping cracks to fractures whose plane resistance is defined by an elastic fracture (shear) stiffness ks and a stick-slip Coulomb threshold.

A complete set of analytical solutions have been derived for (i) the shear displacement in the fracture plane for stresses below the slip threshold and above, (ii) the partitioning between the resistances of the fracture plane on the one hand and of the elastic matrix on the other hand, and (iii) the stress conditions to trigger slip. All the expressions have been checked with numerical simulations. The Young’s modulus and Poisson’s ratio were also derived for a population of fractures. They are controlled both by the total fracture surface for fractures larger than the stiffness length lS (defined by ks and the intact matrix elastic properties) and by the percolation parameter of smaller fractures. These results were applied to power law fracture size distributions, which are likely relevant to geological cases. We show that if the fracture size exponent is in the range 3 to 4, which corresponds to a wide range of geological fracture networks, the elastic properties of the bulk rock are almost exclusively controlled by ks and the stiffness length, meaning that the fractures of size lS play a major role in the definition of the elastic properties.

Keywords: Rock mass, DFN, elastic properties

Latest News
  • Itasca Celebrates 40 Years Itasca is celebrating 40 years of solving geomechanical and hydrogeological challenges through engineering and computer...
    Read More
  • Stability and Stress-Deformation Analyses of Reinforced Slope Failure at Yeager Airport This paper describes the material properties along with the inverse limit-equilibrium and permanent deformation analyses...
    Read More
  • Computers and Geotechnics: Scott Sloan Best Paper Award for 2019 Itasca is pleased to congratulate Dr. Branko Damjanac and Dr. Peter A, Cundall for their...
    Read More

Upcoming Events
8 Mar
FLAC3D 2021 Online, Live Introductory Training: COURSE IS FULL
Three days of general feature training addressing basic concepts and recommended procedures for geotechnical numerical analysis.... Read More
22 Mar
3DEC and UDEC 2021 Online, Live Introductory Training
An introduction to UDEC and 3DEC for application to geotechnical analysis.... Read More
12 Apr
PFC 2021 Online, Live Introductory Training
This four-day course provides guidance in the use of the PFC2D and PFC3D to simulate the mechanical behavior of granular and solid mate... Read More