Software

3D Modeling Survey

This survey is intended for users of FLAC3D or 3DEC. The results of this survey may help Itasca in the development of future versions of FLAC3D and 3DEC.

 
 
1a. Have you used Rhino/Kubrix for mesh generation in FLAC3D or 3DEC? Yes  No
1b. If yes, please rate your experience
(1-5; 1=poor, 5=excellent).
2a. What other solid modeling and mesh generation procedures/software do you use?
2b. Do you use this/these with FLAC3D or 3DEC? Yes  No
3. Would you use a CAD type interface built into FLAC3D or 3DEC that is limited to modeling simple 3D geometries (i.e., extruded 2D mesh)? Yes  No
4a. Do you use programs instead of FLAC3D or 3DEC because you prefer their model/mesh generation capabilities? Yes  No
4b. If so, which?
5. Do you prefer to use built-in mesh generation tools, even when they are limited in scope when compared to third party alternatives? Yes  No
6. If you have further thoughts or suggestions regarding these topics that you would like to share, please add them here.

 
 

Software
About
Consulting
Research
Software
Offices